Pc-concepts Full-Rated Router ADSL2+ Manuel d'utilisateur télécharger pdf (Page 39)

z VPI and VCI: Determine the unique data path your modem uses to communicate with

your ISP.

z Bridge: Enables or disables bridging between the device and your ISP.

z IGMP: Can be used to enable the WAN interface to pass Internet Group Management

Protocol messages it receives to the LAN PCs. You must enable the LAN or USB

interfaces for IGMP.

z IP Address and Subnet Mask: If your ISP has provided a public IP address to your LAN,

enter the address and the associated subnet mask in the boxes provided. (Note: In

bridge configurations, the public IP address may be entered on your PC rather than on

the ADSL/Ethernet router; check with your ISP.).

z Use DHCP: When enabled, your ISP will use DHCP to assign an IP address to the WAN

interface. When disabled, the ISP will either use another protocol, or you must manually

assign an IP address to it. See the appropriate WAN interface help topic for PPP or EoA

interfaces.

z Default Route: When enabled, specifies that the WAN interface specified above will be

used as the default route for your LAN. Whenever one of your LAN computers attempts

to access the Internet, the data will be sent via through this interface.

z Gateway IP Address: Specifies the IP address that identifies the ISP server through

which your Internet connection will be routed.

z PPP Username and Password: The username and password you use to log in to your

ISP. (Note: this is not the same as the user name and password you used to log in to

Configuration Manager.)

z Use DNS: Specifies whether the DNS server addresses that your LAN will use should be

supplied dynamically via the PPP connection each time you connect to the ISP.

If you click Disable, you must configure DNS addresses manually on each PC or in the

fields below.

z Primary/Secondary DNS: Specifies the Primary and Secondary DNS server addresses

provided by your ISP.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 103 104

Pas de commentaire

Pc-concepts Full-Rated Router ADSL2+ Manuel d'utilisateur Page 39